DAPAudio DSA-800 Guide de l'utilisateur télécharger pdf (Page 11)

Mode Selection

The two-position, Mode Select switch (located on the rear panel) configures the amplifier for

either Stereo or Bridged Mono Mode. Amplifiers are factory-configured for Stereo Mode.

Stereo Mode

In Stereo Mode, both channels operate independently, with their input attenuators controlling their

respective levels. Signal at Channel A's input produces output at Channel A's output while signal at

Channel B's input produces output at Channel B's output.

Fig. 4

Important !!!

Absolute minimum nominal load Impedance for stereo operation is 2 Ohm per channel.

Parallel Mode

When set to Parallel Mode, a signal applied to Channel A's input will be amplified and appear at outputs

of both Channels A&B.

Fig. 5

Important !!!

Absolute minimum nominal load Impedance for parallel operation is 2 Ohm per channel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

DAPAudio DSA-800 Guide de l'utilisateur Page 11